To render stations on a map, you need to add a set of filters to the tile request. These filters are sent as query parameters and must be appended after ?.


The tile service will only return results when a combination of powers and connectors are applied. The tile service will also not return any results when combining powerGroups with powers set to all. However you can combine powerGroups with individual powers. An example can be found under powerGroups.

Query parameters

Below you can find an overview of possible query parameters you can apply.


Configures the charging speed powers that will be included in the tiles. Accepts all or an array of kWh values.


Configures the charging speed group powers that will be included in the tiles. There are three StationSpeedType groups available: slow, fast and turbo. You can mix powerGroups with individual powers.


Configures the connector standards that will be included in the tiles. You can send an array with OCPIConnectorTypes.


Configures the amenities that should be present near or at charging stations. Accepts an array of strings with any of the following values:

  • hotel
  • shopping
  • bathroom
  • supermarket
  • playground
  • pharmacy
  • museum
  • coffee
  • park
  • restaurant


Configures if only available stations should be included in the tiles. Accepts a boolean value.


Configures if only stations with a pre-defined preferred operator should be included in the tiles. Learn how to set a preferred operator over here.


You can request the number of displayed stations on the map by using the following API endpoint. If you applied any filters you will need to apply them to the count endpoint as well to make sure you receive the correct count.

Tile Service / Count Request

  • 01
  • 02

It will return a response that looks like this:

Tile Service / Count Response

  • 01
  • 02
  • 03
          {    "count": 158}